bayberry
- Forum posts: 24
Oct 30, 2012, 6:40:40 AM via Website
Oct 30, 2012 6:40:40 AM via Website
The first step: first clean the screen, the dust on the surface of the screen with the included fiber rags and oil completely wipe clean. (Note bound to clean the screen, so as not to cause after the posting of dust, foaming.)
Step 2: Identify the sticky side of the end of film affixed with "step1" label, the surface layer from the film "step2" tab.
Step 3: Post a protective film, gently pull the protector end of film, will be pasted face down, opened protection affixed to the end of the film about one, on the edge of the alignment screen snap, side to paste side will protect the base film slowly pull the paste as slowly as possible and confirm the attached well to avoid bubbles. (Note paste process must be slow, meticulous operation, avoid the finger reaches Protector paste surface.)
Step 4: When the screen affixed the full horizon affixed to the screen, carefully check whether dander or bubbles, then gently push with scratch cards supplied flat edge of the screen to
Step 2: Identify the sticky side of the end of film affixed with "step1" label, the surface layer from the film "step2" tab.
Step 3: Post a protective film, gently pull the protector end of film, will be pasted face down, opened protection affixed to the end of the film about one, on the edge of the alignment screen snap, side to paste side will protect the base film slowly pull the paste as slowly as possible and confirm the attached well to avoid bubbles. (Note paste process must be slow, meticulous operation, avoid the finger reaches Protector paste surface.)
Step 4: When the screen affixed the full horizon affixed to the screen, carefully check whether dander or bubbles, then gently push with scratch cards supplied flat edge of the screen to